PayPal & Sizes & Ordering

All orders will be processed using PayPal Secure Payment Processing payment gateway. Orders can be paid for using a Credit Card or a PayPal account.

For helpful hints and advice on tool sizes and ordering > click here for full details >

Show Cart
Your Cart is currently empty.
Info: Your browser does not accept cookies. To put products into your cart and purchase them you need to enable cookies.

25mm Tool Height


25mm Diamond tool holder.

The 25mm tool holder is designed for use on lathes using 25mm or 1" tooling; it uses exactly the same body as the 20mm size, but has an attached raising block to bring it up to the correct height.
As well as lifting the tool height, the stepped 20mm wide raising block makes setup quicker as it positions the holder square in the bigger tool post, and locates
the center of the shank under the tool clamping bolts.

The holders take both 5/16" and 8mm tool bits (square or round) as standard, but also have the ability to use 1/4" or 6mm tool bits, using the alternative clamp that can be purchased separately.

The smaller tool bits are more cost effective if you are normally taking cuts less than 6mm deep, they are also quicker to re-sharpen.
The same grinding jig is able to sharpen 5/16", 1/4", 8mm, and 6mm tool bits.

Tool holder size will depend on a combination of the size of your lathe and the type of tool post fitted, please check the tool height and the size of the tool slot in your tool post before purchase.

Information on how to work out the tool height can be found on the Tool Selection and Ordering page.

Prices for Australian customers including 10% GST

141 010.001 25mmdiagram 2

1 x Tool Holder - L/H or R/H without sharpening jig = $135.30

1 x Tool Holder - L/H or R/H with sharpening jig = $157.30

2 x Tool Holders - L/H and R/H with sharpening jig = $276.10 


Discounts are available on multiple orders for schools, training centers etc.
Please contact us for more details.





25mm L/H and R/H Diamond Tool Holder kit


25mm L/H Diamond Tool Holder kit with sharpening jig.


25mm L/H Diamond Tool Holder without sharpening jig.


25mm R/H Diamond Tool Holder kit with sharpening jig


25mm R/H Diamond Tool Holder without sharpening jig.


  • «« Start
  • « Prev
  • 1
  • Next »
  • End »»
Results 1 - 5 of 5